Manufacturer and supplier of automatic infrared sensor taps

Tel: 0044 208 133 7680
Fax: 0044 208 711 5674

Home

Monday - Friday 9am-6pm

The tap must be at the OFF position

1. Remove the existing tap aerator by turning it counter-clockwise. (Use the hexnut wrench provided)

2. After aerator is removed, ensure the rubber washer from existing tap is also removed. If the washer is not at the tip of the aerator, it should be inside the water exit of the existing tap.

3. Before installing the adaptor, please check if the tap has the inside (male) or the outside (female) thread. NOTE: Male adaptor type: Insert the rubber washer into the adaptor. Female adaptor type: Do not use the rubber washer. Install Autotaps adaptor by turning its screw clockwise to attach it to your tap (use your ‘thumb’ and ‘index finger’ to tighten it slightly first). Finally secure the adaptor to the tap using the hexnut provided.

CAUTION:
Please be careful of cross-threading, make sure the thread of your tap is perfectly aligned with Autotaps threading before tightening. Hold the adaptor steady with one hand while pulling out the battery compartment with the other to reduce any pressure on the adaptor. Insert new 4XAAA alkaline batteries making sure the batteries are inserted the right way i.e. positive and negative points

Press and hold the Reset button down for 3 seconds to adjust the sensor range automatically. Turn the tap handle to the ON position and Autotaps is ready to use (ensure the temperature of water is checked before usage)

GENERAL REFERENCE:
Programming the Sensor Range/Resetting Autotaps:

1. Turn the tap handle to the OFF position.
2. Press and hold the Reset button for 3 seconds until the green light begin to flash and then release the button.
3. When the green light stops flashing, the new range is set and ready to use (always ensure that you check water temperature before Autotaps usage)

TIP:
If the sensor is too sensitive, try putting your palm 3”-5” away from the sensor range while programming Autotaps sensor range as explained above. Setting Water Temperature and Flow Rate:

1. Turn your tap handle to COLD position
2. Press Manual Override button (ON/OFF/RESET) once
3. While the water is running, move the tap handle to manually adjust water temperature and water rate.
4. After temperature and water rate is set, press manual override button to turn off the water (automatic mode will be active)

PLEASE NOTE:
Some pumps that controls the water system may continue to function when Autotaps is not in use. Try adjusting the tap handle (while at ON position) to different positions until no noise can be heard from the water pumping system.
Low Battery Indicator: For best performance of your Autotaps, we recommend you use batteries (preferably alkaline) of the same type. 10 days before the batteries power is out, a flashing orange colour will indicate

LOW POWER. Changing Battery:

1. Turn the tap handle to the OFF position
2. Pull out the battery compartment to gain access to the batteries
3. Remove the batteries one at a time
4. Replace with new batteries making sure negative (-) and positive (+) ends are installed correctly.
5. Push in the battery compartment firmly back into place (make sure no cables are caught between the battery compartment and the frame of the Autotaps)
6. Adjust the sensor range as explained in ‘Appendix B’ above